Journal cover Journal topic
Wind Energy Science The interactive open-access journal of the European Academy of Wind Energy
https://doi.org/10.5194/wes-2017-20
© Author(s) 2017. This work is distributed under
the Creative Commons Attribution 3.0 License.
Research articles
02 May 2017
Review status
This discussion paper is under review for the journal Wind Energy Science (WES).
Friction torque of wind-turbine pitch bearings – comparison of experimental results with available models
Matthias Stammler1, Fabian Schwack2, Norbert Bader2, Andreas Reuter1, and Gerhard Poll2 1Fraunhofer IWES, Appelstraße 9A, 30167 Hanover, Germany
2IMKT, Leibniz Universität Hannover, Welfengarten 1 A, 30167 Hanover, Germany
Abstract. Pitch bearings of wind turbines are large, grease-lubricated rolling bearings that connect the rotor blades with the rotor hub. They are used to turn the rotor blades to control the power output and/or structural loads of the turbine. Common actuators turning the blades are hydraulic cylinders or electrical motor / gearbox combinations. In order to design pitch actuator systems that are able to turn the blades reliably without imposing an excessive power demand, it is necessary to predict the friction torque of pitch bearings for different operating conditions. In this paper, the results of torque measurements under load are presented and compared to results obtained using different calculation models. The results of this comparison indicate the various sources of friction that should be taken into account for a reliable calculation model.

Citation: Stammler, M., Schwack, F., Bader, N., Reuter, A., and Poll, G.: Friction torque of wind-turbine pitch bearings – comparison of experimental results with available models, Wind Energ. Sci. Discuss., https://doi.org/10.5194/wes-2017-20, in review, 2017.
Matthias Stammler et al.
Matthias Stammler et al.
Matthias Stammler et al.

Viewed

Total article views: 233 (including HTML, PDF, and XML)

HTML PDF XML Total BibTeX EndNote
162 66 5 233 3 3

Views and downloads (calculated since 02 May 2017)

Cumulative views and downloads (calculated since 02 May 2017)

Viewed (geographical distribution)

Total article views: 233 (including HTML, PDF, and XML)

Thereof 224 with geography defined and 9 with unknown origin.

Country # Views %
  • 1

Saved

Discussed

Latest update: 24 Jun 2017
Publications Copernicus
Download
Short summary
Modern wind turbines all share the ability to turn (pitch) the blades around their main axis. By pitching the blades, the aerodynamic forces created by the blades are controlled. Rolling bearings, consisting of two steel rings and balls that roll on raceways between them are used to allow pitching. To design pitch drives, it is necessary to know the losses within the bearings. This article describes how such losses have been measured and compares them against calculation models.
Modern wind turbines all share the ability to turn (pitch) the blades around their main axis. By...
Share